|
STRIDA REPAIR |
|
Change front belt-drive. More repairs | ||
Tools needed: 5 mm and 8 mm unbrako,
trigger, special tool for the retaining ring, holding the spider to the crank -
or a spanner and a hammer.
Then
remove the four unbrakos holding the big belt-drive wheel to the spider - the
grey thing on the photo. Be
aware of the washers, found between the belt-wheel and the spider. Remove the right pedal-arm, see how here. Loosen the retaining ring with the cup-shaped tool - or a spanner, screwdriver or alike and a hammer.
The big wheel is now loose, and can now be swapped to the new one. Replace the retaining ring and tighten it with the right tool - or a hammer and spanner.
Replace the four unbrakos, holding the spider (and pedal-arm) to the crank, and remember the four washers. Tighten them well. It should be possible to hold the "nuts" on the back with your finger. Else, use a flat screwdriver.
Replace the pedal-arm, if you got a Evo3. Any other type; replace the plug holding it pedal-arm. Gentle, lead the belt over the new belt-wheel with your fingers, while the bike is unfolded. If you loosened it, tighten it: Belt-drive adjustment. Go out for a ride and enjoy your Strida! |